2.Orient the Left Upright (31) as shown, and attach it to the Base (48) with two Upright Bolts (40) and two Upright Star Washers (39); do not tighten the Upright Bolts yet.
3.Attach a Wheel (45) to each side of the Base (48) with a Wheel Bolt (40), two Wheel Spacers (44), and a Nut (47) as shown. Do not over- tighten the Wheel Bolts; the Wheels should turn freely.
4.Raise the Uprights (31, 36) so that the Base (48) is flat on the floor and positioned as shown.
Cut the tie holding the Upright Wire (28) in a bun- dle.
See the far right drawing. Wrap the wire tie in the Right Upright (36) around the end of the Upright Wire (28). Then, pull the other end of the wire tie until the Wire Harness is extending from the upper end of the Right Upright.
Make sure that the end of the Upright Wire (28) does not fall into the Right Upright (36).
2 |
|
|
|
|
|
| Latch |
|
|
|
| Holes |
|
|
|
| 48 |
|
|
|
| 31 |
|
|
|
|
|
| 39 |
|
|
| 39 | 40 |
|
|
|
| |
3 |
| 45 | 44 | |
|
| 44 |
| 40 |
|
|
|
| |
|
| 47 |
|
|
| 45 | 44 |
|
|
| 44 | 47 |
|
|
|
|
|
| |
| 40 | 48 |
|
|
4 | 28 |
|
| |
|
|
| ||
Wire Tie
31 | 36 | 28 |
Large
Hole
Wire
Tie
48
7