ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included hex key and your own phillips screwdriver | . |
Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly.
3/4" Screw | 1” Tek Screw | 1 1/4” Tek Screw | Cover Screw | |||
3/8" Star |
| Pulse Bar Star | Endcap Screw | Silver Pulse Bar | Console Screw | |
| Washer | Screw |
| |||
Washer |
|
|
|
|
| |
2 | 3/4" Upright Bolt | 1" Upright Bolt | 1 1/4" Bolt |
1. Make sure that the power cord is unplugged. |
| 76 |
|
1 | 75 |
| |
With the help of a second person, carefully tip |
|
| |
|
|
| |
the treadmill onto its left side as shown. Partially |
|
|
|
fold the Frame (26) so that the treadmill is more |
| Post |
|
stable. Do not fully fold the Frame until the |
|
| |
|
|
| |
treadmill is completely assembled. |
| Wire |
|
Identify the Right Upright (76) which has a |
|
|
|
RIGHT sticker. Hold the Right Upright near the | 76 |
|
|
Base (81). Insert the Upright Wire (75) into the |
|
|
|
Right Upright until the Upright Wire is extending |
|
|
|
from the upper end of the Right Upright. Note: | 81 |
|
|
Make sure that the Upright Wire is extending |
| 85 | |
from the side of the post as shown in the inset |
|
|
|
drawing. Remove the tie from the Upright Wire. | 26 |
|
|
|
|
| |
Thread a 2 3/4" Upright Bolt (85) and a 1" Upright |
| 83 | 84 |
|
| ||
Bolt (84) with 3/8" Star Washers (83) into the |
|
|
|
Base (81) and the bottom of the Right Upright |
|
|
|
(76). Do not tighten the Upright Bolts yet. |
|
|
|
6 |
|
|
|