ParaBody 827 manual Ir --- t-/ 2

o

FIGURE 2

STEP 2:

•Attach eight 1 Xl" GLIDES (39) to the ends the CARRIAGE (5) as shown in FIGURE 2 using the following steps:

•Thoroughly clean all surfaces where the 1 X I" GLIDES (39) are to be attached.

•Remove the 1 Xl" GLIDES (39) from the paper backing and firmly apply them to all shown surfaces.

9SECURELY attach one 1-1/4" SQ. RUBBER BUMPER (24) to the CARRIAGE (5) as shown in FIGURE 2.

,~.----------------------------------------

".. "..

6~_ ........

". :. .....

FIGURE 3

STEP 3:

•Insert two 3 X 2" GUIDES (21) into the ends of the ROLLER PAD SUPPORT (6) as shown in FIGURE 3.

•Assemble two ROLLER PADS (11) to the ROLLER PAD SUPPORT (6) using two STARLOCK COLLARS (23).

•SECURELY assemble one SPRING PIN ASSEMBLY (35) to the spring pin barrel on the ROLLER PAD SUPPORT (6). See FIGURE 3.

FI

STEP 8:

Attach the CABLE (12) from the TOP BOOM (4) to the CARRIAGE (5) using one QUICK LINK (37) as shown in FIGURE 8.

(IMPORTANT! Securely tighten QUICK LINK.)

•Place one 4-112" PULLEY (15) into the loop of the CABLE (12) below the second and third PULLEY of the TOP BOOM (4) as shown in FIGURE 8.

SECURELY assemble two 1/4 x 2 x 7-114'''' PLATES (9) to each side of the 4-1/2"									PULLEY (15) using one 3/8 X 2-1/4"
BOLT (29), two 3/8" WASHERS (25), and one 3/8" LOCK NUT (26). See FIGURE 8.										,Ir ---t-/2--1
I	1/2	I	1/2	I	1/2	I	1/2	1 --	t - /2 ----

?L--l-...l-I--L---!tL-i--L1-L--IT---l...--LI--l.--!f~--LI--L-~1--L--l-1--l-----LT--I-_I'----'----'~

7 12