17.Attach the Seat (31) to the Seat Frame (8) with two M6 x 76mm Screws (64) and two M6 Washers (60).
Attach the Bumper (36) to the Seat Frame (8) with an M4 x 16mm Screw (61).
Insert the Pad Tube (35) into the Seat Frame (8).
18.Grease an M10 x 62mm Button Bolt (75). Attach the Leg Lever (9) to the Seat Frame (8) with the Button Bolt and an M10 Nylon Locknut (56). Do not overtighten the Nylon Locknut; the Leg Lever must be able to pivot easily.
19.Slide four Foam Pads (32) onto the Pad Tube (35) and the Leg Lever (9).
20. Set the Seat Frame (8) onto the Upright Base (5).
21.Make sure that all parts have been properly tight- ened. The use of the remaining parts will be explained in ADJUSTMENTS, beginning on the next page.
17 |
| |
31 |
| |
35 |
| |
| 8 | |
61 |
| |
36 | 60 | |
| 64 | |
18 | 8 | |
56 | ||
| ||
9 | Grease | |
75 | ||
| ||
19 |
| |
32 |
| |
32 | 32 | |
| ||
| 35 | |
9 | 32 | |
20 |
| |
8 |
| |
| 5 |
12