ProForm PFCCSY2926.1 user manual

7.Note: This step may be easier if the resistance system is tipped over forward (see drawing 7b).

Route the Long Cable (42) around a 90mm Pulley (38). Insert an M10 x 132mm Button Bolt (69) into a Guard (37), a Cable Trap (39), the Pulley, an M10 Washer (59), an 8mm Spacer (41), another Guard (37), and another 8mm Spacer (41). Note:

The end of the Button Bolt must be flush with the edge of the last Spacer. Make sure that the Cable Trap is oriented to hold the Cable in the groove of the Pulley.

See drawing 7b. Insert the 90mm Pulley (38) into the Rear Frame (10). Push the M10 x 132mm Button Bolt (69) through the Rear Frame and the Left Upright (6). Finger tighten an M10 Nylon Locknut (56) onto the Button Bolt. Do not tighten the Nylon Locknut yet.

8.Wrap the Long Cable (42) under a 90mm Pulley (38). Attach the Pulley, a Cable Trap (39), and two Guards (37) to the Base (2) with an M10 x 52mm Patch Screw (80) and an M10 Washer

(59). Make sure that the Cable Trap is oriented to hold the Cable in the groove of the Pulley.

9.Attach a Pulley Bracket (17) to the indicated “U”- channel (18) with an M10 x 132mm Button Bolt (69), two M10 Washers (59), and an M10 Nylon Locknut (56).

Wrap the Long Cable (42) over a 90mm Pulley

(38).Attach the Pulley inside the Pulley Bracket

(17)with an M10 x 41mm Button Bolt (71) and an

M10 Nylon Locknut (56).

7a
42		39
41	59		69
		38	37
		37
7b
		69
38
		6	10
		56
8
42
		59
37		39	80
			37
		38
		2
9
56		59	18
			56
71
			59
42		17	69
	38

9