JVC FS-J50, FS-J60 Common Operations, Setting the Clock, Turning On the Power, Press CLOCK/TIMER

English

Common Operations

Setting the Clock

Before operating the unit any further, first set the unit’s clock. When you plug the AC power cord into the wall outlet, “AM 12:00” starts flashing on the display.

You can set the clock whether the unit is on or off.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start over from step 1.

•For FS-J60 only, you can also use CLOCK/TIMER on the unit for this operation.

1	Press CLOCK/TIMER.	CLOCK
		/TIMER

The hour digits start flashing on the display.

To change the clock

1Make sure the (timer) indicator is not lit on the display.

•If it is lit, press and hold CLOCK/TIMER until it goes off.

2Press CLOCK/TIMER repeatedly until the unit enters the clock setting mode (the hour digits start flashing on the display).

First time you press CLOCK/TIMER, the unit enters the timer setting mode. (See page 20.)

3Repeat steps 2 and 3 of the procedure of “Setting the Clock.”

4Press and hold CLOCK/TIMER again so that the (timer) indicator goes off.

2 Press UP or DOWN to	UP
adjust the hour, then	/TIMER
	CLOCK
press CLOCK/TIMER.	DOWN
The minute digits start flashing.

3 Press UP or DOWN to adjust the minute, then press CLOCK/TIMER.

To check the clock time during play

On the remote control ONLY:

Press DISPLAY (grey-colored). DISPLAY

• Each time you press the button, the source indication and the clock time alternate on the display.

•When you unplug the AC power cord or if a power failure occurs

The clock is reset to “AM 12:00” right away. If this happens, set the clock again.

•The clock may gain or lose 1 to 2 minutes per month If this happens, reset the clock.

Turning On the Power

To turn on the unit, press	STANDBY/ON
STANDBY/ON .
The STANDBY/ON lamp lights
green and “HELLO” appears on
the display.

•When you press the source button—CD 3/8, TAPE 2 3, FM/AM, and AUX, the unit automatically turns on and starts playback if the source is ready.

To turn off the unit (standby), press STANDBY/ON again.

The STANDBY/ON lamp lights red and “GOOD BYE” appears on the display.

•“AM 12:00” flashes on the display until you set the built-in clock. After setting the clock, the clock time will appear on the display while the unit is on standby.

The illumination and display brighten only for 4 seconds by pressing DIMMER.

•A little power is always consumed even while the unit is on standby.

To switch off the power supply completely, unplug the AC

power cord from the AC outlet.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “AM 12:00” right away, while the tuner preset stations (see page 12) will be erased in a few days.

9