3.Attach a Pedal (31) to one of the Pedal Arms (12) with three #8 x 3/4” Round Head Screws (16) as shown.
Repeat this step to attach a Pedal to the other Pedal
Arm (not shown).
4.Make sure that there are two Pedal Arm Bushings (42) in each Pedal Arm (12).
Identify the Left Handlebar (8) (there is a decal on the Left Handlebar for identification). Slide a Handlebar Spacer (39) and one of the Pedal Arms (12) onto the Left Handlebar as shown (these parts fit tightly; it may be helpful to use the rubber mallet). Refer to the
PART IDENTIFICATION CHART on page 5 and iden-
tify the 3/4” Axle Caps (43). Tap a 3/4” Axle Cap onto the Left Handlebar.
Repeat this step to attach the other Pedal Arm (12) to the Right Handlebar (9).
5.Make sure that there are two Rear Pedal Arm Bushings (11) in each Pedal Arm (12).
Slide a Pedal Arm Spacer (41) and the left Pedal Arm
(12) onto the left Crank Arm (59) (these parts fit tight-
ly; it may be helpful to use the rubber mallet). | Be |
careful not to confuse the left Pedal Arm with the |
|
right Pedal Arm (not shown); look at the position |
|
of the Left Handlebar (8) to identify the left Pedal |
|
Arm. |
|
Tap a 3/4” Axle Cap (43) onto the left Crank Arm (59). |
|
Repeat this step to attach the right Pedal Arm (not |
|
shown). |
|
7
3 |
|
| 31 |
| 12 |
| 16 |
4 |
|
| 9 |
| 8 |
| 12 |
| 39 |
42 |
|
43 |
|
12 |
|
5 |
|
8 | 59 |
| 41 |
| 11 |
| 12 |
| 43 |