ProForm PFSY6806.0 user manual Repeat this step for the Seat Frame

Page 12

21.Insert a Pad Tube (17) into the Leg Developer

(6).Next, slide two Leg Pads (23) onto the Pad Tube. Then, slide two Pad Covers (30) onto the Leg Pads, and press a 19mm Large Round Cap

(118)into each Pad Cover.

Repeat this step for the Seat Frame (4).

22.Attach the Curl Pad (20) to the Curl Post (9) with two M6 x 30mm Screws (87).

23.Make sure that all parts are properly tightened before using the weight system. The use of the remaining parts will be explained in the ADJUST- MENTS section, beginning on the following page.

21
118
30	4
	4
	23
	17
	6
	23
	30
	118
22
20
	9
	87

Image 12

Contents QUESTIONS? Model No. PFSY6806.0 Serial NoCall TOLL-FREE Mon.-Fri., 6 a.m.-6 p.m. MSTTable of Contents Important Precautions Before YOU Begin Right SideLeft Side Assembly Make Things Easier for YourselfLocknut the Wheel must pivot easily Repeat this step with the other Wheel CapPage Locknut yet Tighten the M10 Nylon Locknuts 108 used in steps 3108 Page Page Repeat this step on the other side of the Dip Arm Repeat this step for the Seat Frame Adjustments Adjusting the DIP HandlesAdjusting the Press ARM Adjusting the DIP ARMAdjusting the Seat Attaching the Pulley HousingsAttaching the Curl PAD Attaching the LEG DeveloperAttaching the Curl BAR Attaching the Squat BARAttaching the Handles Moving the Weight System Changing the Weight SettingAdjusting the Cable Weight Resistance Chart Cable DiagramWeight Exercise Guidelines Muscle Chart Cooling DownStaying Motivated R0906A Key Qty DescriptionPart Identification Chart M10 x 55mm Carriage BoltExploded Drawing A-Model No. PFSY6806.0 Exploded Drawing B-Model No. PFSY6806.0 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT