ProForm 831.28622.1 Ful to avoid pinching the Wires. Attach, Avoid pinching, Button Bolts yet

5. While another person holds the Upright (2) in	5	2
the position shown, connect the Extension Wire
(68) to the Lower Wire Harness (73).		45
				7
Push the Extension Wire (68) and the Lower	33
Wire Harness (73) down into the Frame (1).
Slide the Upright (2) onto the Frame. Be care-
ful to avoid pinching the Wires. Attach the			68
Upright with two M10 x 74mm Button Bolts (7),
				Avoid pinching the
two M10 Split Washers (45), and two M10			73
Nylon Locknuts (33). Do not tighten the				wires during this step
Button Bolts yet.	1
6. Identify the Left Handlebar (6), which is marked	6
with a sticker. Insert the Left Handlebar into one
of the Handlebar Legs (5); make sure that the
Handlebar Leg is turned so the hexagonal
holes are on the indicated side. Attach the
Left Handlebar to the Handlebar Leg with two
M8 x 45mm Button Bolts (50) and two M8
Nylon Locknuts (38). Make sure that the				8
Nylon Locknuts are inside of the hexagonal
holes. Do not tighten the Button Bolts yet.			Grease
Insert the Pivot Axle (26) into the Upright (2),	6
and center the Pivot Axle. Apply a generous	55			26
amount of the included grease to both ends of
the Pivot Axle.	56			47
				2
Turn a Handlebar Spacer (47) so that the small		69		38
arrow on the Handlebar Spacer is pointing	46			5
toward the floor, and slide the Handlebar	50
Spacer onto the post on the Left Handlebar (6).
				Hexagonal
Next, slide the Left Handlebar onto the Pivot
				Holes
Axle (26).
Slide a Handlebar Washer (55) and a Wave				5
Washer (69) onto an M8 x 25mm Patch Screw
(56), and tighten the Patch Screw into the Pivot
Axle (26). Then, press the tabs on a Handlebar
Cap (46) into the Handlebar Spacer (47).
Assemble the Right Handlebar (8) and the other
Handlebar Leg (5) in the same way.
	7