1.
To make assembly easier, read the information on page 5 before you begin assembling the elliptical exerciser.
Identify the Stabilizer (9) which has round Endcaps (21) on the ends. While another per- son lifts the front of the Frame (1), attach the Stabilizer to the Frame with two M10 x 75mm Carriage Bolts (34) and two M10 Nylon Locknuts (33).
2.While another person lifts the back of the Frame (1), attach the other Stabilizer (9) to the Frame with two M10 x 75mm Carriage Bolts (34) and two M10 Nylon Locknuts (33).
3.The Console (23) requires four 1.5V “D” batter- ies (not included); alkaline batteries are recom- mended. IMPORTANT: If the elliptical exercis- er has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries into the Console. If you do not do this, the console displays or other electronic components may become dam- aged. Remove the battery cover from the Console, and insert four batteries into the Console. Make sure that the batteries are ori- ented as shown by the markings on the bat- tery cover. Then, reattach the battery cover.
4.While another person holds the Console (23) in the position shown, connect the console wire to the Extension Wire (68).
Attach the Console (23) to the Upright (2) with the four Console Screws (59) included with the Console. Be careful to avoid pinching the wires.
Attach the Water Bottle Holder (29) to the Upright (2) with two M4 x 22mm Screws (63).
1 |
|
|
|
| 21 |
| 34 |
|
|
| 1 |
| 34 |
|
| 9 | 33 |
| 21 | |
|
| |
2 |
| 33 |
|
| |
| 33 |
|
| 1 |
|
| 9 | 34 |
|
| |
3 |
|
|
|
| 23 |
|
| Batteries |
|
| Battery |
|
| Cover |
| Batteries |
|
4 | 23 |
|
|
| |
| Console Wire |
|
68
29 59
2 
63
6