Assembly

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included hex keys and your own Phillips screwdriver , adjustable

wrench , and rubber mallet .

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the parts bag, check to see if it has been preassembled. If a part is missing, call 1-888-533-1333.

M8 Split	M10 Split	M8	Handlebar	M10
Washer (28)–4	Washer (45)–2	Washer (71)–4	Washer (55)–2	Washer (35)–2
Wave	Large Wave	M8 Nylon	M10 Nylon	M4 x 22mm
Wave	Large Wave	M8 Nylon	M10 Nylon	Screw (63)–2
Washer (69)–2	Washer (76)–2	Locknut (38)–4	Locknut (33)–6
M8 x 25mm Patch		M8 x 52mm Button		M10 x 27mm
Screw (56)–2		Screw (27)–4		Patch Screw (40)–2
M10 x 74mm Button Bolt (7)–2			M10 x 75mm Carriage Bolt (34)–4
M8 x 45mm Button Bolt (50)–4			M6 Bolt Set (25)–2
		5