JVC TH-C50 Connections, For TH-C60 Before assembling, When assembling a speaker without stand

Connections

Do not connect the power cord until all other connections have been made.

Connecting the satellite (front, center, surround) speakers

7Assembling the speakers — TH-C60/TH-C50

7For TH-C60: Assemble front speakers and surround speakers.

7For TH-C50: Assemble front speakers.

For the surround speakers of TH-C50, see “Connecting the surround speakers — TH-C50”. (See page 10.)

For TH-C60

Before assembling —

•Prepare a Phillips screwdriver (not supplied).

•Take care not to drop any component part while assembling; otherwise, it may cause damage to the floor or injury.

1

Speaker

Stand

Screw M5 x 40 mm/M5 x 1-5/8 inches (supplied)

2When assembling a speaker without stand:

		Stand (4)	Base plate (4)
Front speaker	Surround
(SP-THC60F) (2)	speaker
	(SP-THC60S) (2)

•Check the model name of each speaker from the label on the rear to locate each speaker correctly.

For TH-C50

Front speaker	Stand (2)	Base plate (2)
(SP-THC60F)(2)

Stand (or speaker directly)*

Speaker

A: Use these screws (M4 x

45 mm/M4 x 1-13/16 inches) when assembling the speaker with the base plate.

Base plate

Screw M4 x 20 mm/M4 x 13/16 inches (supplied)*

Assembled speakers

or

With stand: Refer to steps 1 to	Without stand: Refer to steps
3.	2 and 3.

*When assembling the speaker with the base plate, use the screws A.

3

Red White

Black Black

You can route the speaker cord by using speaker cord clamp (supplied).

9