JVC TH-C40, TH-C60, TH-C50 manual Operating external components with the remote control

Operating external components with the remote control

The buttons described below are used on pages 14 and 15.

Number buttons

Remote control mode selector

(play button)

NOTE

•Manufacturers’ codes are subject to change without notice.

•Set the codes again after replacing the batteries of the remote control.

Operating the TV

7To set the manufacturer’s code

1Slide the remote control mode selector to TV.

2Press and hold F TV.

Keep the button pressed until step 4 is finished.

3 Press ENTER.

4 Press number buttons (1-9, 0) to enter the manufacturer’s code (2 digits).

Examples:

For a Hitachi TV: Press 1, then 0.

For a Toshiba TV: Press 0, then 8.

	Manufacturer	Code	Manufacturer	Code
	JVC	01*	Samsung	12
	Hitachi	10	Sanyo	13, 14
	Magnavox	02	Sharp	06
	Mitsubishi	03	Sony	07
	Panasonic	04, 11	Toshiba	08
	Philips	15	Zenith	09
	RCA	05
5	* “01” is the initial setting.
	Release F TV.

If there is more than one code listed for corresponding brand, try each one until you enter the correct one.

7Operation

Aim the remote control at the TV.

IMPORTANT

Before using the remote control to operate a TV;

• Set the remote control mode selector to TV.

The following buttons are available:

F TV:	Turns TV on and off.
TV VOL +/–:	Adjusts the volume.
TV/VIDEO:	Selects the input mode (either TV or
CH +/–:	VIDEO).
	Changes the channels.
1-10, 0, h10 (100+):	Selects the channel.
TV RETURN:	Alternates between the previously selected
	channel and the current channel.

NOTE

• The operating buttons may differ depending on manufacturers.

14