JVC UX-A52R manual Playing Back a Tape, To play both sides-Reverse Mode

Playing Back a Tape

You can play back type I, II, and IV tapes.

1 Press TAPE open/close 0 on the unit.

The unit automatically turns on, the electronic swing panel slides downward, and the cassette loading slot appears.

If a cassette is already in the cassette loading slot, it is ejected.

Cassette loading slot

To stop during play, press 7.

To fast-wind or rewind the tape, press ¢ or 4.

•When the tape direction is

¢: Fast-winds the tape.

4 : Rewinds the tape.

•When the tape direction is

4 : Fast-winds the tape.

¢: Rewinds the tape.

To eject the cassette, press TAPE open/close 0.

•After ejecting the cassette, press TAPE open/close 0 again to close the electronic swing panel.

DO NOT press TAPE open/close 0 during tape play.

2

3

Insert a cassette with the exposed part facing left.

The cassette is pulled in, then the electronic swing panel slides upward automatically.

Press TAPE 2 3.

The tape starts playing.

•Each time you press the button, the tape direction changes as follows:

: Plays the front side.

: Plays the reverse side.

Tape indicator

Reverse mode

Tape direction

When the tape plays to the end, the cassette deck

automatically stops if the reverse mode is set to or

. (See “To play both sides—Reverse Mode”.)

To play both sides—Reverse Mode

You can set the cassette deck to play just one side of a tape, both sides once, or both sides continuously.

•You can set this mode only when a cassette is already in the cassette deck.

On the remote control ONLY:

Press REV. MODE.

•Each time you press the button, the reverse mode changes as follows:

: To only play back one side (front or reverse.)

: To play back the front and reverse sides once.

: To play back both front and reverse sides continuously.

To check the clock time while playing back a tape

On the remote control ONLY:

Press DISPLAY (not on number buttons.)

•Each time you press the button, the source information and the clock time alternate on the display.

The use of the C-120 or thinner tape is not recommended, since characteristic deterioration may occur and this tape easily jams in the pinch rollers and the capstans.

– 26 –