STEP 14 (See Diagram 14 & 15)
A.) Tighten all the nuts and bolts previously installed.
B.) Before putting the Weight Plates on, now move the machine to the corner of the room or place where you will use the machine.
C.) Lift up the Selector Rod and install the Weight Plates. To install the plates, hold the plate at an angle and place between the two guide rods then drop it down. Make sure the grooves on the plastic covers all face up. See diagram below. It is strongly recommended to spay some lubricant such as
D.) Check the tightness of the cable loop. If the loop is too loose, shorten the chain installed in STEP 9E.
E.) Attach the Weight Stack Cover (#28) to the machine and secure it with four ∅3/4” Washers (#106) and M10 x ½” Allen Bolts (#100).
DIAGRAM 14
19