Impex MSS-7500 manual Diagram

Page 10

STEP 4 (See Diagram 4)

A.) Attach the Leg Developer (#9) to the open bracket on Main Seat Support (#3). Secure it with one Leg Developer Axle (#21), two M10 x ¾” Allen Bolt (#33), and two Ø ¾” Washers (#36). Do not over tighten the Bolts. Make sure the Leg Developer is able to swivel.

B.) Insert two Foam Tubes (#10) halfway through the holes on the Leg Developer. Push four Foam Rolls (#19) onto the Tubes from both ends. Plug four Foam Roll End Caps (#26) into the ends.

C.) Slide an Olympic Sleeve (#24) onto the weight post on Leg Developer. Attach a Spring Clip (#20) onto the Sleeve.

DIAGRAM 4

9

Image 10
Contents Weight Bench Impex INCTable of Contents Before YOU BeginImportant Safety Notice Page Hardware Pack Page Assembly Instruction See DiagramSecurely tighten all Nuts and Bolts Diagram Diagram Page Parts List Description Impex INC