Impex PHC-696 manual #40

Page 7

STEP 3 (See Diagram 3)

A.)

Attach the Seat Bracket (#6) to the pivot on the Sliding Block (#5). Push two ¾” x

 

3/8” Bushings (#53) through the holes on the Seat Bracket into both ends of the pivot.

B.)

Attach the Backrest Supports (#12) to the Bushings. Secure it with one M10 x 7 ¼”

 

Hex Bolt (#42), two ¾” Washers (#39), and one M10 Aircraft Nut (#40).

C.)

Attach the Backrest Incline Support (#11) to the Backrest Supports (#12). Secure it

 

with a M10 x 7 ¼” Hex Bolt (#42), two ¾” Washers (#39), and one M10 Aircraft Nut

 

(#40).

D.)

Attach the other end of Backrest Incline Support (#11) to the open bracket on the Main

 

Seat Support (#4). Secure it with one M10 x 3 3/8” Allen Bolt (#44), two ¾”

 

Washers (#39), and one M10 Aircraft Nut (#40).

E.)

Use the Sliding Block to select desired Backrest Incline position. NOTE: Do not over

 

tighten the Bolts and Nuts. Make sure the Backrest Supports are able to incline.

 

DIAGRAM 3

6

Image 7
Contents Powerhouse Bench Toll-Free Customer Service Number Mon. Fri a.m. 5 p.m. PST Important Safety Notice Hardware Pack Assembly Instruction Diagram #40 Diagram Diagram Page Parts List Impex INC