STEP 6 (See Diagram 6 & Cable Loop Diagram)
A.) Insert the 242” Upper Cable (#35) through the swivel pulley bracket
B.) Install a Ball Stopper (#86) onto the end of the Cable. Attach a
C.) Attach a Short Chain (#40) in between the opening on the Connector and secure it with a M10 x 1 3/8” Allen Bolt (#72), two Ø ¾” Washers (#87), and one M10 Aircraft Nut (#88).
D.) Draw the Cable over the Pulley and pull through the Cable sleeve on the Right Lat Bar Frame. Draw the Cable along the Frame towards the back of the machine to the Pulley previously installed. Draw the Cable around the Pulley then downward to an Angled Floating Pulley Bracket (#28).
E.) Attach two Pulleys (#45) to the Bracket. Secure them with one M10 x 2 ¾” Allen Bolt (#68), two Ø ¾” Washers (#87), and one M10 Aircraft Nut (#88).
F.) Draw the Cable around the back Pulley then upward to the open bracket underneath the Lat Bar Frame Bracket (#15). Attach a Single Pulley Bracket (#98) to the bracket. Secure it with one M10 x 1 3/8” Allen Bolt (#72), two Ø3/4” Washers (#87), and one M10 Aircraft Nut (#88). Attach a Pulley to the Bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#71), two Ø ¾” Washers (#87), and one M10 Aircraft Nut (#88).
G.)Draw the Cable around the Pulley then back down to the Angled Floating Pulley Bracket (#28) again. Let the Bracket hanging for now.
H.) Draw the Cable around the front Pulley then upward towards the Pulley on the Left Lat Bar Frame (#16).
I.) Draw the Cable over the Pulley then along the Left Lat Bar Frame towards the front of the machine. Insert the Cable through the cable sleeve and over the
J.) Repeat the Procedures B & C above to install a Ball Stopper,
K.) Connect the Lat Bar (#22) or Single Handles (#59) to the Short Chains using
13