Impex PHE 9000 manual See Diagram

Page 23

STEP 2 (See Diagram 2)

A.) Attach four Bushings (#21) to a Seat Support Frame (#6).

B.) Attach a Backrest Support (#7) to the rear of the Seat Support Frame (#6). Align the holes and secure them with one M10 x 1 ¾” Allen Bolt (#31) and ¾” Washer (#36). Repeat the same procedure to install the other side.

C.) Attach two Bushings to the pivot on the Sliding Block (#8). Attach two Bushings to each Backrest Supports (#7). Align the holes and secure them with one M10 x 6 ¾” Allen Bolt (#32), two ¾” Washers (#36), and one M10 Aircraft Nut (#38). Do not over tighten the nut and bolt. The Supports need to swivel on the Bolt.

D.) Attach two Bushings to the pivot on the Main Frame (#1). Loosen and pull the Lock Knob on the Sliding Block (#8). The Sliding Block needs to be able to slide on the Chromed Incline Adjustment Bar (#9). Align the two Seat Support Frames (#6) to both ends of the pivot on Main Frame. Secure them with one M10 x 8 ¼” Allen Bolt (#33), two ¾” Washers (#36), and one M10 Aircraft Nut (#38).

E.) Use the Lock Knob on the Sliding Block (#8) to adjust and secure the backrest incline position.

22

Image 23
Contents Powerhouse Elite Toll-Free Customer Service Number Mon. Fri a.m. 5 p.m. PST Important Safety Notice Smith Machine Hardeware Pack Smith Machine Hardeware Pack Smith Machine Hardeware Pack Smith Machine Assembly Instruction See Diagram DIAGRAM2 See Diagram Diagram Diagram Cable Loop Diagram See Diagram 6 & Cable Loop Diagram Diagram See Diagram 7 & Cable Loop Diagram See Diagram 8 & Cable Loop Diagram See Diagram 9 & Cable Loop Diagram Page ’ty Smith MachineMULTI-PURPOSE Bench Hardware Pack MULTI-PURPOSE Bench Assembly Instruction See Diagram Diagram Diagram Diagram Page MULTI-PURPOSE Bench Parts List Info@impex-fitness.com Impex INC