Assembly Instruction

Tools Required to Assemble the Machine: Two Adjustable Wrenches and Allen Wrenches

NOTE: It is strongly recommended this machine to be assembled by two or more people to avoid possible injury.

STEP 1 (See Exploded Diagram)

A.)	Attach a base Frame (#19) to the end of Main Base Frame (#4). Secure it with one
	Bracket (#18), two M10 x 2 ¾” Carriage Bolts (#6), two ∅	¾” Washers (#9), and M10
	Aircraft Nuts (#23). Repeat the same procedure to connect the other Base Frame
	(#19) on the other side.
B.)	Attach the Left Rear Vertical Frame (#12) to the Base Frame (#19). Align the holes to
	the Bracket (#18). Secure it with two M10 x 2 ¾” Carriage Bolts (#6), ∅ ¾” Washers
	(#9), and M10 Aircraft Nuts (#23). Repeat the same procedure to install the other
	side.
C.)	Attach the Front Vertical Frame (#25) to the Base Frame (#19). Secure it with three
	M10 x 5/8” Allen Bolts (#8) and ∅ ¾” Washers (#9). Secure the Front Vertical Frame
	(#25) to the Left Rear Vertical Frame (#12) with two M10 x 5/8” Allen Bolts (#8) and
	∅ ¾” Washers (#9). Repeat the same procedure to install the other side.
D.)	Attach one Diagonal Support (#5) to the Main Base Frame (#4). Attach the other end
	to the Rear Vertical Frame (#12). Secure the top and the bottom of the Diagonal
	Support (#5) with two M10 x 2 ¾” Carriage Bolts (#6), ∅	¾” Washers (#9), and M10
	Aircraft Nuts (#23). Repeat the same procedure to install the other side.
E.)	Insert two Weight Holders (#13) into the two holes on the Rear Vertical Frame (#12).
	Secure each Weight Holder with one M10 x 1” Allen Bolt (#24) and ∅ ¾” Washer
	(#9). Slide two Olympic Sleeves (#14) onto the Holders. Secure each Sleeve with a
	M8 x ½” Allen Set Screw (#16). Repeat the same procedure to install the other side.
F.)	Insert the Right & Left Bar Catches (#1) & (#20) into the selected holes on the Front
	Vertical Frames (#25).