JVC UX-G70 manual @ Speakers, Preparing the remote control, Before plugging in the System

@Speakers

•When connecting the speaker cords, match the polarity of the speaker terminals: red color to (+) and black color to (–).

•By using QP Link (Quick Portable Link), you can easily start playing back a portable audio device on this unit when connecting it to the LINE IN jack. See page 12 for details.

•Connect an audio component to the LINE OUT jack if the component is not equipped with a digital input terminal.

•If an external device is not equipped with a stereo mini plug audio output, use a plug adaptor to convert the stereo mini plug to the corresponding plug of the audio output.

Insert

From right CAUTION:

speaker

Press and hold

Release

Red

Black	From left
	speaker

Before plugging in the System

Set the correct voltage for your area with the voltage selector on the rear.

					Use a screwdriver to set the
		110V	VOLTAGE		voltage selector to the same
220V			SELECTOR		voltage as where you are
				127V	plugging in the unit. (See also
					the back cover page.)
	230V-240V

Preparing the remote control

•DO NOT connect more than one speaker to each terminal.

•DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.

When connecting a portable audio device (LINE)

Portable audio device (Digital Audio Player, etc.)

At the front panel

To the audio output	Stereo mini plug
	(not supplied)
	To the audio input
Portable audio device with
the audio input
(Digital Audio Player, etc.)

R6(SUM-3)/AA(15F)

•Dispose of batteries in the proper manner, according to federal, state, and local regulations.

DO NOT recharge, short, disassemble, heat the battery or dispose of it in a fire.

When using the remote control

Point the top of the remote control toward the remote sensor as directly as possible. If you operate it from a diagonal position, the operating range (approx. 5 m) may be shorter.

5