PYLE Audio PFTL31404.1 user manual Right Upright be careful not to damage the Upright Wire

2. Identify the Right Upright (24) and the Left Upright (99).		2		42
	Straighten the Upright Wire (42), and feed it into the lower
	end of the Right Upright (24) and out of the upper end.
	Next, hold the Right Upright against the right side of the			24
	Base (69); make sure that the Right Upright is turned		69
	so that the upper end is angled in the direction
	shown. Hand tighten two 3” Bolts (37) with one Star
	Washer (63) and two Washers (45) into the Base and the	63
	Right Upright; be careful not to damage the Upright
	Wire.	37	45		Small
	With the help of a second person, carefully tip the tread-
	mill onto its other side. Attach the Left Upright (99) and				Holes
	the other Wheel (not shown) as described above and in
	step 1. Make sure that the two small holes in the Left
	Upright are positioned as shown. Note: There is not				99
	an upright wire on the left side.
3.	With the help of a second person, carefully tip the tread-	3
	mill so that it is flat on the floor, and raise the Uprights		35	71
	(99, 24) to the vertical position as shown.
	Hold the Crossbar (25) between the Left Upright (99) and					72
	the Right Upright (24). Attach the Crossbar with two 3”	37		25	Large
	Bolts (37). Firmly tighten the Bolts.
	Identify the Right Handrail (72), which has a large round			42	Hole
	hole in the location shown. Route the Upright Wire (42)
	through the hole in the Right Handrail. Next, hand tighten		99	35
	a 2 1/4” Bolt (35) into the upper end of the Right Handrail						37
	and the Right Upright (24). Then, hand tighten a Handrail
	Bolt (27) with a Washer (45) into the lower end of the
	Right Handrail and the Right Upright. Be careful not to
	pinch the Upright Wire. Firmly tighten the Bolts.		45	27
	Attach the Left Handrail (71) in the same way. Note:						24
	There is not an upright wire on the left side.
					45		27

7