Huffy VP8100 manual 07/03 211636C

Page 13

5.Bounce top (4) and middle (5) pole assembly onto bottom pole section (6) using a wood scrap as shown. Bounce until the top and middle pole assembly no longer moves toward the taped reference mark on the bottom pole. NOTE: Pole sections should have a 3-1/2” (9 cm) overlap minimum.

IMPORTANT!:

Holes in top (4) and bottom pole (6) sections MUST align to correctly position elevator system toward playing surface.

4

5

6

RODS SHOWN ARE

FOR VISUAL

REPRESENTATION

OF ALIGNMENT

AND ARE NOT

SUPPLIED WITH THE HARDWARE

WOOD SCRAP

(NOT SUPPLIED)

6.Insert bolts (7) into bracket (9) as shown. Install bolt (14) through bracket (9) and bottom pole section (6) and secure with nut (12) as shown.

14

7

9

6

12

9

13

07/03

P/N 211636C

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Portable System Before YOU Start U.S.1-800-558-5234 and Canada Safety Instructions Warranty Card Front Parts List See Hardware Identifier Hardware Identifier Bolts & Screws Hardware Identifier Steel Spacers Section a Assemble the Base Item #57 Mark pole sections with tape not supplied as shown 07/03 211636C Item #8 07/03 211636C FIG. a Or side access Section B Attach the Backboard 07/03 211636C 211636C 07/03 07/03 211636C Install net clips NET Installation 211636C 07/03 USE EYE Protection When Installing Springs Section C Apply Height and Moving Label & Height Adjustment
Top Page Image Contents