Huffy VP8100 manual 211636C 07/03

Page 24

8.Support pole on sawhorse. Attach backboard assembly to top pole section (4) as shown. Install pole cap (46). NOTE: Two people are recommended for this step. Use caution; elevator assembly is heavy.

 

39

 

40

4

38

39

 

 

45

 

46

 

45

 

38

 

48

 

40

 

37

9.Install upper elevator tubes (43) to triangle plates (45) as shown. Install handle assembly to lower elevator tubes (40) using bolt (37), spacers (44), and nut (39) as shown. NOTE: Before going on to next step, set adjustable system assembly to the 10’ (3.05 m) setting.

28

40

39 44

44

40

37

39

43

38

45

38

37

43

P/N 211636C 07/03

24

Image 24
Contents Portable System Before YOU Start U.S.1-800-558-5234 and Canada Safety Instructions Warranty Card Front Parts List See Hardware Identifier Hardware Identifier Bolts & Screws Hardware Identifier Steel Spacers Section a Assemble the Base Item #57 Mark pole sections with tape not supplied as shown 07/03 211636C Item #8 07/03 211636C FIG. a Or side access Section B Attach the Backboard 07/03 211636C 211636C 07/03 07/03 211636C Install net clips NET Installation 211636C 07/03 USE EYE Protection When Installing Springs Section C Apply Height and Moving Label & Height Adjustment