Huffy M671111 manual Align dimple of top pole section

Page 13

2.Identify pole sections.

5

Identification Sticker

4

6

While maintaining alignment, bounce middle pole section (5) into top section (4)

3.using a wood scrap as shown until the top pole no longer moves toward the pole

identification sticker on the middle pole.

IMPORTANT!:

CAUTION!

THE IDENTIFICATION STICKER IS

 

 

Align dimple of top pole section (4)

LOCATED 5" FROM THE END OF

THE POLE. WHEN PROPERLY

POUNDED TOGETHER, THE POLE

into trough of middle pole section (5)

MINIMUM OVERLAP, LEAVING 1-

as shown.

 

SECTIONS SHOULD HAVE A 3-1/2"

 

POLE AND THE IDENTIFICATION

 

 

1/2" BETWEEN THE OVERLAPPING

 

 

STICKER.

pole em

ID

 

 

STICKER

 

TROUGH

 

5

5"

 

 

 

pole middle

 

 

1-1/2"

 

 

DIMPLE

4

 

 

 

HOLE

WOOD SCRAP

 

(NOT SUPPLIED)

 

 

13

07/05

ID# M671111

Image 13
Contents Portable System Before YOU Start ID# 556790 05/05 Safety Instructions Warranty Card Front Parts List See Hardware Identifier Hardware Identifier Bolts & Screws Hardware Identifier Plastic Spacers Caps & Clips Section a Assemble the Base 07/05 ID# M671111 Handle, Right Carriage Bolt P/N Screw P/N Align dimple of top pole section Dimple Hole 07/05 ID# M671111 Tighten just until washers 17 stop moving FIG. a Section B Attach the Backboard 07/05 ID# M671111 ID# M671111 07/05 Install Slam Jam Rim to Backboard ID# M671111 07/05 Install upper elevator tubes 35 to triangle If Using Sand 2 Gallons of ANTI-FREEZE is not Required Section C Apply Height and Moving Label & Height Adjustment