Huffy M671111 manual Before YOU Start

Page 2

BEFORE YOU START!

To ensure optimal playability of backboard system, a close tolerance fit between the elevator components and hardware is required. Test-fit large bolts into large holes of elevator tubes, backboard brackets, and triangle plates. Carefully rock them in a circular motion to ream out any excess paint from holes if necessary.

NOTE: Not all items pictured are included with every model.

ID# M671111

07/05

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Portable System Before YOU Start ID# 556790 05/05 Safety Instructions Warranty Card Front Parts List See Hardware Identifier Hardware Identifier Bolts & Screws Hardware Identifier Plastic Spacers Caps & Clips Section a Assemble the Base 07/05 ID# M671111 Handle, Right Carriage Bolt P/N Screw P/N Align dimple of top pole section Dimple Hole 07/05 ID# M671111 Tighten just until washers 17 stop moving FIG. a Section B Attach the Backboard 07/05 ID# M671111 ID# M671111 07/05 Install Slam Jam Rim to Backboard ID# M671111 07/05 Install upper elevator tubes 35 to triangle If Using Sand 2 Gallons of ANTI-FREEZE is not Required Section C Apply Height and Moving Label & Height Adjustment
Top Page Image Contents