3. While maintaining alignment, bounce assembly and bottom pole section (6) together as shown until they no longer move toward identification sticker.
CAUTION!
THE IDENTIFICATION STICKER IS
LOCATED 5" FROM THE END OF
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE POLE
SECTIONS SHOULD HAVE A
MINIMUM OVERLAP, LEAVING
BETWEEN THE OVERLAPPING
POLE AND THE IDENTIFICATION
STICKER.
IMPORTANT!
Align dimple of middle pole section (5) into trough of bottom pole section (6) as shown.
Bottom pole
5" | ID |
STICKER
Bottom pole
DIMPLE
HOLE
4
5
6 
WOOD SCRAP
(NOT SUPPLIED)
11 | 11/05 | ID# M731321 |