Huffy M731321 manual Align dimple of top pole into trough of middle pole as shown

Page 10

2. While maintaining alignment, bounce pole top (4) and middle section (5) together as shown until they no longer move toward identification sticker. Upright assembly.

CAUTION!

THE IDENTIFICATION STICKER IS

LOCATED 5" FROM THE END OF

THE POLE. WHEN PROPERLY

POUNDED TOGETHER, THE POLE

SECTIONS SHOULD HAVE A 3-1/2"

MINIMUM OVERLAP, LEAVING 1-1/2"

BETWEEN THE OVERLAPPING

POLE AND THE IDENTIFICATION

STICKER.

IMPORTANT!

Align dimple of top pole section (4) into trough of middle pole section (5) as shown.

pole em

ID

 

STICKER

5"

 

 

pole middle

 

1-1/2"

 

DIMPLE

 

HOLE

5

4

WOOD SCRAP

(NOT SUPPLIED)

ID# M731321

11/05

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Write Model Number From Box Here Not all items pictured are included with Every model Safety Instructions Warranty Card Get to know the basic parts of your basketball system Parts List See Hardware Identifier Hardware Identifier Bolts and Screws Hardware Identifier Steel Spacers Section a Assemble the Base Align dimple of top pole into trough of middle pole as shown Dimple Hole Do not Over 11/05 ID# M731321 Front Side 9/16 3/4 Toward Pole 11/05 ID# M731321 ID# M731321 11/05 11/05 ID# M731321 Fig. a Fig. C ID# M731321 11/05 Do not Leave Assembly Unattended When Empty IT MAY TIP Over Install Slam Jam Rim to Backboard USE EYE Protection Install net 26 as shown If Using Sand Do not Allow Children to Adjust Height
Top Page Image Contents