Huffy DH9300 manual Section a Assemble the Poles

Page 9

SECTION A: ASSEMBLE THE POLES

1.Correctly identify each pole section. Mark pole sections with tape as shown.

2

5" TAPE

(13 cm)

1

3

5" TAPE

(13 cm)

2.Bounce middle pole section (2) into top pole section (1) together using a wood scrap as shown until they no longer move toward taped reference mark.

NOTE: Pole sections should have a 3-1/2" (9 cm) minimum overlap.

2

1

IMPORTANT!:

Position middle pole so that the warning label is on the same side as the 1/2" (cm) diameter holes of the top pole.

Wood Scrap

9

05/03

P/N 211689C

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Portable Basketball System Before YOU Start U.S.1-800-558-5234 and Canada Safety Instructions Front Warranty Card Hardware Identifier Height Adjustment Section a Assemble the Poles Tape Reference Mark Hammer or Mallet Section B Assemble the Base211689C 05/03 Page 211689C 05/03 05/03 211689C 211689C 05/03 Carefully reposition entire assembly as shown Section C Assemble the Elevator System & Backboard To Avoid Rapid 211689C 05/03 FIG. a Page 05/03 211689C Insert spacer into strut assembly as shown 05/03 211689C 211689C 05/03 05/03 211689C Section D Install Front Cover & Handle 05/03 211689C FIG. a Section E Install NET Clips and NET NET Installation Section F Securing the System Section G Apply Height and Moving Label Height AdjustmentSection H Troubleshooting Guide
Top Page Image Contents