Huffy DH9300 manual Section G Apply Height and Moving Label, Height Adjustment

Page 34

SECTION G: APPLY HEIGHT AND MOVING LABEL

1.Apply Height Adjustment and Moving Label (57) to front of pole, where it is clearly visible. Remove protective film from acrylic backboard.

57

HEIGHT ADJUSTMENT

TO ADJUST BACKBOARD:

1. Grasp handle and squeeze trigger.

2. Raise or lower to desired height.

3. Release trigger.

MOVING SYSTEM

1

32

4

1.Adjust basketball backboard height to lowest position.

2.Rotate handle forward until wheels engage ground.

3.Move basketball system to desired location.

4.Rotate handle back to original position.

5.Reattach ground restraint and check system for stability.

202052 02/03

P/N 211689C 05/03

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Portable Basketball System Before YOU Start U.S.1-800-558-5234 and Canada Safety Instructions Front Warranty Card Hardware Identifier Height Adjustment Section a Assemble the Poles Tape Reference Mark Section B Assemble the Base Hammer or Mallet211689C 05/03 Page 211689C 05/03 05/03 211689C 211689C 05/03 Carefully reposition entire assembly as shown Section C Assemble the Elevator System & Backboard To Avoid Rapid 211689C 05/03 FIG. a Page 05/03 211689C Insert spacer into strut assembly as shown 05/03 211689C 211689C 05/03 05/03 211689C Section D Install Front Cover & Handle 05/03 211689C FIG. a Section E Install NET Clips and NET NET Installation Section F Securing the System Height Adjustment Section G Apply Height and Moving LabelSection H Troubleshooting Guide
Top Page Image Contents