Huffy DH9300 manual Tape Reference Mark

Page 10

3.

IMPORTANT! Holes in top (1) and bottom pole (3) sections MUST align to correctly position elevator system toward playing surface.

While maintaining alignment, bounce assembly and lower section (3) together as shown until they no longer move toward taped reference mark.

NOTE: Pole sections should have a 3-1/2" (9 cm) minimum overlap.

1/2" (1.27 cm) DIAMETER HOLES OF TOP POLE

1

2

TAPE REFERENCE

MARK

3

WOOD SCRAP

(NOT SUPPLIED)

P/N 211689C 05/03

10

Image 10
Contents Portable Basketball System Before YOU Start U.S.1-800-558-5234 and Canada Safety Instructions Front Warranty Card Hardware Identifier Height Adjustment Section a Assemble the Poles Tape Reference Mark Section B Assemble the Base Hammer or Mallet211689C 05/03 Page 211689C 05/03 05/03 211689C 211689C 05/03 Carefully reposition entire assembly as shown Section C Assemble the Elevator System & Backboard To Avoid Rapid 211689C 05/03 FIG. a Page 05/03 211689C Insert spacer into strut assembly as shown 05/03 211689C 211689C 05/03 05/03 211689C Section D Install Front Cover & Handle 05/03 211689C FIG. a Section E Install NET Clips and NET NET Installation Section F Securing the System Height Adjustment Section G Apply Height and Moving LabelSection H Troubleshooting Guide