5. |
| 6. Insert pole into base assembly as shown. | |
Install rod (8) thru holes in bottom pole section (3) | |||
| and eyebolt (7) as shown. |
|
|
|
|
| |
|
|
|
|
2
3
8
7
TOP VIEW OF
BASE ASSEMBLY
7
1
3
7. Bring pole foward and secure pole to front panel (4) at 34” (86.4 cm) mark on pole. Tighten nuts evenly until snug. NOTE: Equal rotations on each side of
34”
(86.4 cm)
Mark
9
SIDE VIEW OF ASSEMBLY
Pole
11
10
4
IMPORTANT! | Pole |
Make sure items (10) and (11) are used in this assembly.
9
10
4
12 |
11 |
BOTTOM VIEW OF FRONT PANEL ASSEMBLY
12
8. NOTE: Two people recommended for this step. Tilt unit foward using caution and secure pole
bottom to base using nut (12) and disk (13), 12 a deep socket is recommended.
7
13
IMPORTANT!
DO NOT OVER
TIGHTEN.
5
6
4
P/N 205932 | 5/99 | 5 | 5/99 | P/N |