IMPORTANT!
ONCE POLE SECTIONS ARE POUNDED TOGETHER- THEY CANNOT BE TAKEN APART
2. Align poles using alignment marks. First, pound top and middle poles together by bouncing them on a scrap piece of wood on the ground as shown in FIG A. until they no longer move toward pole identification stickers. THEN add bottom pole section and pound together in the same way FIG B.
CAUTION!
THE IDENTIFICATION STICKER IS LOCATED 5" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A
BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.
FIG. A.
4
5
| IMPORTANT! |
DIMPLE |
|
TROUGH |
|
GORGE |
|
RINNE |
|
TROUGH | |
CANAL | |
| ID STICKER |
5" | ID |
STICKER | |
| |
| ID STICKER |
| DIMPLE |
| HOLE |
Wood Scrap
(NOT SUPPLIED)
FIG. B.
4
5
6
ID# M611701 12/05 | 8 |