STEP 4 (See Diagram 4)
A.) Attach two Ø ¾” Leg Developer Bushings (#27) to the Leg Developer (#11). Attach the Leg Developer to the Front Post (#10). Secure it with one M10 x 3 1/8” Allen Bolt (#46), two Ø ¾” Washers (#53), and one M10 Aircraft Nut (#57). Do not over tighten the Nut and Bolt. Make sure the Leg Developer is able to swivel.
B.) Insert three Foam Tubes (#13) halfway through the holes on the Leg Developer and Front Post. Push six Foam Rolls (#33) onto the Tubes from both ends. Plug six Foam Roll End Caps (#32) into the ends.
C.) Slide an Olympic Sleeve (#35) onto the weight post on Leg Developer. Attach a Spring Clip (#36) onto the Sleeve.
DIAGRAM 4
10