JVC CA-MXG65V Introduction, About This Manual, Precautions, Installation, Power sources, Others

Page 6
Introduction

English

Introduction

We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference.

About This Manual

This manual is organized as follows:

The manual mainly explains operations using the buttons and controls on the unit. You can also use the buttons on the remote control if they have the same or similar names (or marks) as those on the unit.

If operation using the remote control is different from that using the unit, it is then explained.

Basic and common information that is the same for many functions is grouped in one place, and is not repeated in each procedure. For instance, we do not repeat the information about turning on/off the unit, setting the volume, changing the sound effects, and others, which are explained in the section “Common Operations” on pages 9 to 11.

The following marks are used in this manual:

Gives you warnings and cautions to prevent damage or risk of fire/electric shock.

Also gives you information which is not good for obtaining the best possible performance from the unit.

Gives you information and hints you had better know.

Precautions

Installation

Install in a place which is level, dry and neither too hot nor too cold — between 5˚C (41˚F) and 35˚C (95˚F).

Install the unit in a location with adequate ventilation to prevent internal heat built-up in the unit.

Leave sufficient distance between the unit and the TV.

Keep the speakers away from the TV to avoid interference with TV.

DO NOT install the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or vibration.

Power sources

When unplugging from the wall outlet, always pull the plug, not the AC power cord.

DO NOT handle the AC power cord with wet hands.

Moisture condensation

Moisture may condense on the lens inside the unit in the following cases:

After starting heating in the room

In a damp room

If the unit is brought directly from a cold to a warm place Should this occur, the unit may malfunction. In this case, leave the unit turned on for a few hours until the moisture evaporates, unplug the AC power cord, and then plug it in again.

Others

Should any metallic object or liquid fall into the unit, unplug the unit and consult your dealer before operating any further.

If you are not going to operate the unit for an extended period of time, unplug the AC power cord from the wall outlet.

DO NOT disassemble the unit since there are no user serviceable parts inside.

If anything goes wrong, unplug the AC power cord and consult your dealer.

– 1 –

Image 6
Contents CA-MXG68V INSTRUCTIONSCA-MXG65V LVT0700 -001AWarnings, Cautions and Others G-1Caution --switch G-2 English1.Do not remove screws, covers or cabinet CA-MXG65V CA-MXG68V G-3Caution Proper Ventilation CA-MXG65V CA-MXG68VIMPORTANT FOR LASER PRODUCTS G-4CLASS LASER PRODUCT REPRODUCTION OF LABELSPower sources PrecautionsInstallation IntroductionContents EnglishLocation of the Buttons and Controls Front PanelEnglish Front Panel Display windowEnglish Remote Control EnglishGetting Started Connecting AntennasPutting the Batteries into the Remote Control Unpacking2Insert the end of the speaker cord into the Connecting Speakers3Release the finger from the clamp terminalCancelling the Display Demonstration Connecting Other EquipmentAdjusting the Voltage Selector On the unit ONLY3 Press 4or ¢to adjust the Turning On or Off the PowerSetting the Clock Press CLOCK/TIMERTo turn down the volume level temporarily Adjusting the VolumeSetting the AM Tuner Interval Spacing Selecting the SourcesSurround modes Reinforcing the Bass SoundSelecting the Sound Modes SEA Sound Effect Amplifier modes ROCK POP CLASSICPresetting Stations Tuning in a StationTuning in a Preset Station Press and hold TUNING + orLoading Discs When playing a CD-Ror CD-RWPlaying Back Discs Playing Back the Entire Discs - Continuous PlayBasic Disc Operations Programming the Playing Order of the TracksProgram Play Press PROGRAMProhibiting Disc Ejection - Tray Lock Playing at Random - Random PlayRepeating Tracks or Discs - Repeat Play 1 Load a discPlaying Video CDs To adjust the color system - NTSC/PALPress SLOW on the remote control during playback Special Plays for Video CDsTo stop and cancel the video intro, press Press STILL on the remote control duringPress ON SCREEN on the remote control To stop and cancel the highlight, pressPlaying Video CDs with PBC Function High-resolutionstill picturesPlaying Video CDs with Using Menu Screens 2 Prepare Video CDs3 Press PBC on the unit Playing Video CDs without Using Menu Screen2 Prepare a Video CD 4 Start playback of the Video CD1 Press EJECT 0 for the deck you want to use Playing Back TapesPlaying Back a Tape 3 Close the cassette holder gentlyRecording a Tape on Deck B To clean the head, capstan, and pinch rollerRecording On the unit ONLY 1 Press EJECT 0 for the deck BOn the unit ONLY 1 Press TAPE 3, then Dubbing TapesCD Synchronized Recording Press DUBBINGMicrophone Mixing Using the MicrophonesSinging Along Karaoke 4 Press KARAOKE on the remoteOn the remote control ONLY Using Multiplex Discs - Multiplex Sound MPXAdjusting Key Control On the remote control ONLY 1 Start the source CD1 Press CLOCK/TIMER repeatedly Using the TimersUsing Daily Timer 2 Press CLOCK/TIMER again8 Press SET to complete the Daily Timer setting Using Recording Timer7 Press 4or ¢to set the volume level Press CLOCK/TIMER repeatedly6 Select the preset station Using Sleep TimerTimer Priority 4 Set the on-timeyou want the unitHandling cassette tapes MaintenanceHandling discs To clean the discTroubleshooting EnglishAmplifier section - CA-MXG65V/CA-MXG68V SpecificationsSupplied accessories TunerEN, CH VOLTAGE SETTINGIMPORTANT for mains AC line 0501KSMMDWSAMPage Page