Assembly
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.
STEP 3 | Slide the Guide Rods (19) into the holes located on the Left and Right |
| Frames (1 & 2). Now apply the Lithium Grease included with your bolt |
| pack onto the Guide Rods (19). |
| Next, slide a Weight Bumper (37) onto each Guide Rod (19). Slide the |
| Weight Plates according to the appropriate configuration as shown on |
| Page 12. Last, slide the Top Plate (34) onto the guide rods. Note: Be |
| sure the weight pin holes face towards the inside of the unit. Screw |
| the Pulley Bracket (30) into the Top Plate (34). |
| Secure the Guide Rods (19) to the top of the Left and Right Frames |
| (1 & 2) using Allen Bolts M10X50 (57), Spring Washers M10 (61), and |
| Washers M10 (60). |
|