INSTALLATION | INSTALLING LOG SET | ||
1. | Set | ||
Continued | |||
| Figure 14. Make sure middle section at bot- | ||
Equipment |
| ||
| tom of log is seated into "U" shaped cutout in | ||
Shutoff Valve |
| ||
| center of heater base. Log will fit securely on | ||
|
| ||
|
| base. IMPORTANT: Make sure log does not | |
Gas Meter |
| cover any burner ports and does not touch the | |
|
| stove cavity (see Figure 14). | |
| 2. | Fasten back panel to stove with four (4) bolts | |
|
| and washers removed in step 4 of Unpacking, | |
|
| page 7. Make sure product identification label is | |
Control Valve |
| located on the outside lower | |
3. | Place freestanding stove in desired position | ||
Location |
| being careful not to damage gas connections. | |
Figure 11 - Checking Gas Joints on |
| Be sure to maintain clearances to combustibles | |
Natural Gas Unit |
| and wall clearances as outlined on page 8. | |
|
|
INSTALLING ROD AND SCREEN
1.Insert rod through small rings located at top of screen (see Figure 12).
2.From back of stove, insert rod into hole located inside right front of stove as shown in Figure 13.
3.Slip left side of rod down into slot on inside left front of stove (see Figure 13).
Rod
Rings
Figure 12 - Assembling Rod and Screen | ||||
Slot on Inside | Rod with | Hole on Inside | ||
Left Front of | ||||
Right | Front of | |||
Screen | ||||
Stove | ||||
Stove |
| |||
Assembled |
| |||
|
| |||
|
|
|
Log Set
|
| Middle Section | |
|
| at Bottom of | |
|
| Log Set | |
|
| Burner | |
|
| "U" Shaped | |
Heater |
| Cutout in | |
| Chassis | ||
Base |
| ||
|
| ||
Figure 14 - Installing | |||
| Log Set | ||
|
| Burner Porting Areas | |
(double slotted | |||
rectangular openings | |||
Log Set |
| ||
|
| ||
Safety |
|
| |
Pilot |
|
| |
Location |
|
|
Figure 15 - Top View of One-Piece Log
Set on Gas Log Heater
Figure 13 - Installing Screen Into Stove
(View From Back of Stove)
12 | www.desatech.com |