JVC XL-Z132BK, XL-Z232BK Installing the batteries, Compu Link connection, Battery replacement

Installing the batteries

(XL-Z232BK Only)

To install the batteries in the remote control unit

Before operating the remote control unit, install two batteries.

1. Remove the rear cover of the remote control unit by pressing down and simultaneously pulling it backwards.

2. Install batteries. Be sure that the batteries are installed with correct polarity, (+) and (–).

3. Attach the rear cover by sliding it back into position.

Notes

Incorrect use of batteries can cause corrosion or damage. Note the following points to lengthen battery life.

ÖInstall batteries observing the correct polarity, (+) and (–).

ÖDo not use new and old batteries simultaneously.

ÖBatteries with similar shapes may have different voltage ratings. Be sure to use the correct batteries.

ÖRemove batteries from the remote control unit if it will not be used for a long period of time.

ÖDo not expose batteries to heat or flame.

Battery replacement

Service life of batteries depends on the condition of use; standard life is about one year. When the batteries become weak, the operating distance of the remote control unit becomes short . If this happens, replace the batteries R03(UM-4)/AAA(24F) with new ones.

Note

ÖThe lower the temperature, the shorter the battery life.

BEFORE USING FOR THE FIRST TIME

COMPU LINK connection

JVC’s COMPU LINK Remote Control System provides unified control over system components connected with COMPU LINK. Connecting JVC audio components with the COMPU LINK jacks automatically controls relative operations between components and facilitates vari- ous operations. With the COMPU LINK connection to an amplifier or receiver, you can operate XL-Z132BK/XL-Z232BK with the amplifier or receiver’s remote control unit. Synchronized recording is also avail- able with this feature.

Connecting the COMPU LINK cord

The COMPU LINK-3 SYNCHRO jacks are used to output and input the control signal for the COMPU LINK remote control system.

COMPU LINK-compatible products are provided with the jacks marked COMPU LINK-1, COMPU LINK-2 or COMPU LINK-3, referring to the COMPU LINK version. XL-Z132BK/XL-Z232BK is equipped with COMPU LINK-3. You can connect XL-Z132BK/XL-Z232BK also to a component with a lower COMPU LINK versions. But, in that case, only the lower versions’ features will be available.

Plug the supplied COMPU LINK cord into the COMPU LINK-3 SYNCHRO jack on the rear panel of XL-Z132BK/XL-Z232BK. Plug the other end into the COMPU LINK jack of the other component. If there are two COMPU LINK jacks, plug it into either of them.

Connect to the COMPU LINK-3 (SYNCHRO) jack of another com- ponent eqipped with the Compu Link remote control system.

Rear panel of this unit

DIGITAL OUT

	OPTICAL
OUTPUT	COMPULINK-3	AC IN
	(SYNCHRO)

LEFT

RIGHT

Supplied COMPU LINK cord

Amplifier or receiver Cassette deck Turntable

Page 6