Optional Assembly Instructions

The LifeCORE Sport Trainer comes with this optional handlebar post STABILITY PLUG [108].

This STABILITY PLUG [108] can not be assembled by the manufacturer as it would increase the carton size and reduce the container loading which inturn would increase the cost. So in order to keep costs down to our valued customers and still provide the STABILITY PLUG [108] these optional assembly instructions where devised.

The STABILITY PLUG [108] will help stabilize the HANDLEBAR POST [007]. If you feel that the HANDLEBAR POST [007] is already stable enough then you need not bother with this optional assembly. However if when the HANDLEBAR POST [007] is set at maximum and you can feel the HANDLEBAR POST [007] wobble slightly then this optional assembly will eliminate the wobble.

a)With the LifeCORE Sport Trainer fully assembled, lower the HANDLEBAR POST [007] to level 1, the lowest level and do not tighten KNOB [105].

b)Insert the STABILITY PLUG [108] with the tabs pointing to the rear of the machine as illustrated in the diagram below, into the bottom of the HANDLEBAR POST [007].

c)Ensure the STABILITY PLUG [108] is completely inserted into the HANDLEBAR POST [007] as shown in the picture below.

007

105

TAB

108	STABILITY PLUG [108]