Weider 831.150680 user manual

5.	Lubricate the M10 x 178m Bolt (46). Attach the	5
	Right and Left Backrest Frames (7, 8) to the
	Frame (2) with the Bolt, two M10 Washers (41),
	and an M10 Nylon Locknut (36).
		Lubricate
	Align an adjustment hole in the Right and Left
	Backrest Frames (7, 8) with the indicated hole in
	the Frame (2). Insert the Backrest Pin (26)	46
	through the Frame and the Backrest Frames, and				8
		41
	secure it with the Spring Clip (25).		7		41
	Tighten all of the M10 Nylon Locknuts (36)				36
	used in steps 1–3. Tighten the four M6 x	26
	38mm Screws (39) used in step 4.
			2		25
6. Press three 45mm Square Inner Caps (22) into the		6		36
	Leg Lever (9). Press a 1” Round Inner Cap (27)		22
	into the indicated end of the Weight Tube (15).
	Attach the Weight Tube (15) to the Leg Lever (9)		9
	with the M8 x 58mm Bolt (42), two M8 Washers
	(43), the Spacer (30), and an M8 Nylon Locknut		30	28
	(44). Press the 1” Angled Cap (28) onto the back	22			45
	of the Weight Tube.	42		43	Lubricate
			43
		15
	Lubricate an M10 x 72mm Bolt (45). Attach the				1
	Leg Lever (9) to the Front Leg (1) with the Bolt		44
	and an M10 Nylon Locknut (36). Do not over-
			22
	tighten the Nylon Locknut; the Leg Lever	27
	must be able to pivot easily.
7. Orient the Seat (11) with the wide end on the side		7
	shown. Attach the Seat to the Frame (2) with four	11
	M6 x 16mm Screws (37).
		Wide End
				2
			37
			37
		8