9. | Press two 19mm Round Inner Cap (21) into the | 9 |
|
|
| Support Rod (14). Insert the Support Rod into a |
|
| |
|
|
|
| |
| set of holes in the Uprights (1). Turn the Support |
|
|
|
| Rod so the locking pin is wrapped around the |
| 14 |
|
| Upright. | 21 |
| |
|
|
|
| |
|
| Locking |
| 1 |
|
| Pin |
|
|
|
|
|
| 21 |
10. | Press four 25mm Square Inner Caps (19) into the | 10 |
|
|
| two Backrest Tubes (7). |
|
| |
|
|
|
| |
| Attach the Backrest Tubes (7) to the Backrest (8) | 8 |
|
|
| with four M6 x 38mm Screws (32) and four M6 |
|
| 19 |
| Washers (22). Do not tighten the Screws yet. |
|
| |
|
|
|
| |
|
|
|
| 22 |
|
|
| 7 |
|
|
| 19 | 22 | 32 |
|
|
| ||
|
|
| 32 |
|
11. | Lubricate an M10 x 142mm Bolt (23) with grease. | 11 |
|
|
| Attach the Backrest Tubes (7) to the welded tube |
|
| |
|
|
|
| |
| on the Bench Frame (3) with the Bolt, two M10 |
|
|
|
| Washers (30), and an M10 Nylon Locknut (31). | 30 |
| |
| Do not overtighten the Locknut; the Backrest |
| ||
|
|
|
| |
| Tubes must be able to pivot easily. | 31 |
|
|
|
|
|
| |
| Tighten the M6 x 38mm Screws (32) used in | 7 |
|
|
| step 10. |
|
| |
| 3 |
|
| |
|
|
| 30 | |
|
|
|
| |
|
|
| Tube | 23 |
|
|
|
| |
|
|
| Lubricate | |
12. | Attach the Seat (9) to the Bench Frame (3) with | 12 | 9 |
|
| four M6 x 16mm Screws (24). |
| ||
|
|
| ||
|
|
| 3 |
|
13. | Make sure that all parts are properly tightened |
|
|
|
| before you use the weight bench. The use of |
| 24 | 24 |
| all remaining parts will be explained in ADJUST- |
| ||
|
|
| ||
| MENTS, beginning on the following page. |
|
|
|
9