Weider 831.159390 Find the Butterfly Cable 85-this is, Trap must be oriented as shown and be

CABLE ASSEMBLY

23. Locate and open the parts bags labeled	23
“CABLE ASSEMBLY” and “PULLEYS.”
During steps 23 through 58, refer to the
CABLE DIAGRAMS on pages 30 and 31 of
this manual to verify proper cable routing.
Before beginning this section, fully unwind the
five Cables and identify the Cables by com-
paring the lengths and the ends. The approxi-
mate length of each Cable, in inches, is listed
after the key number in the drawing.
IMPORTANT: While assembling the Cables,
do not overtighten the bolts and nuts
attaching the pulleys. The pulleys must be
able to turn freely.
	85—72.5”
	86—103”
	87—148.75”
	89—209.5”
	88—243”
24. Find the Butterfly Cable (85)—this is the	24
shortest Cable. Slide one end of the Butterfly
Cable onto a 3/8” x 1” Bolt (77). Insert the
Bolt through the bracket on the Right Arm
(5).Thread a 3/8” Nylon Locknut (42) onto the
Bolt, but do not fully tighten it. Leave just	77
enough room for the Cable to pivot.
	85
	5
	42
25. Wrap the Butterfly Cable (85) around a 3 1/2”	25
Pulley (82) as shown. Attach the Pulley and a
Cable Trap (80) to the bracket on the Leg	42
Press Upright (4) with a 3/8” x 2” Bolt (50)
and a 3/8” Nylon Locknut (42). The Cable	82
Trap must be oriented as shown and be
positioned to hold the Cable in the groove
of the Pulley.	50
	80
	4
	85

13