Weider 831.159390 user manual Cable Assembly

Page 18

CABLE ASSEMBLY

38.Attach the Rear Cable (87) to the Leg Lever (15) with a 5/16” x 3” Bolt (92), a 5/16” Washer (20), a 5/8” x 9/16” Bushing (61) and a 5/16” Nylon Locknut (40).

39.Find the Low Cable (89)—this is the short- est of the two remaining Cables. Feed the Low Cable under the 3 1/2” Pro Pulley (97) and the row tube on the Pulley Base (79).

The ball on the Cable must be on the side shown. Tighten the 3/8” x 2” Bolt (50) and 3/8” Nylon Locknut (not shown).

40.Wrap the Low Cable (89) around a “V” Pulley (81). Slide the “V” Pulley and a Large Cable Trap (83) onto the 3/8” x 4” Carriage Bolt (57) in the Weight Base (14). Tighten a 3/8” Nylon Locknut (42) onto the Carriage Bolt.

41.Wrap the Low Cable (89) around a 3 1/2” Pulley (82). Attach the Pulley to the bracket on the Weight Base (14) with a 3/8” x 2” Bolt (50) and a 3/8” Nylon Locknut (42).

18

38
15
87
40
61
20	92
	92
39
	Row Tube
	89
	97
	79
	50
	Ball
40
42	89
42
83
81	57
	57
14
41
	89
50
	82
	42
14

Image 18

Contents Patent Pending Model No Serial No SEARS, Roebuck and CO., Hoffman ESTATES, ILTable of Contents Full 90 DAY WarrantyImportant Precautions Dimensions Before YOU BeginFrame ASSEMBLY-PLASTIC AssemblyFollowing Tools not Included are Required for Assembly LocknutsNylon Locknuts Do not fully tighten the Nylon LocknutsGrooves are on the indicated side of each Stack of Weights Fully tighten the Nylon LocknutsLocknut 40. Do not overtighten the Nylon Weight Tubes are in the pin grooves in the upper Weights Nylon Locknuts yet ARM Assembly ARM Assembly ARM Assembly Find the Butterfly Cable 85-this is Trap must be oriented as shown and bePositioned to hold the Cable in the groove Pulley End with Two holes Should be Down Cable Assembly Post Wide Tabs Must be On this Side Cable Assembly Cable Assembly Cable must be routed from the direction shown Find the Press Cable 88. Attach the end Plates 31. The Cable must be routed from Cable Trap is turned to hold the Cable PlaceLocknut until step Cable Assembly Seat Assembly Seat AssemblySeat Assembly High Pulley HOW to USE the Home GYM System Changing the Weight SettingAdjusting the LEG Lever Adjusting the LEG Press PlateAttaching the AB Strap to the AB Pulley Station Weight Resistance Chart PlatesTROUBLE-SHOOTING and Maintenance Tightening the CablesCable Diagrams Press Cable High Cable Long U Bracket Leg Press-13Butterfly Cable Left Arm Right Arm Page Page X 3 1/4 Bolt Part LIST-Model No Qty DescriptionExploded DRAWING-Model No R0698AQUESTIONS?