Weider 831.159390 user manual Post Wide Tabs Must be On this Side

CABLE ASSEMBLY

33.Attach the High Cable (86) to a Small “U” Bracket (32) with a 1/4” Nylon Locknut (44) and a 1/4” Washer (37). Do not completely tighten the Nylon Locknut. It should be threaded onto the end of the Cable so only a couple of threads are showing above the Nylon Locknut, as shown in the inset drawing.

Attach the Small “U” Bracket (32) to the indi- cated Weight Tube (25) with a 5/16” x 1 3/4” Bolt (68) and a 5/16” Nylon Locknut (40).

34.Locate the Rear Cable (87)—this is again the shortest remaining Cable. Wrap the Rear Cable around a 3 1/2” Pulley (82). Attach the Pulley and two Pulley Covers (62) to the Ab Upright (1) with a 3/8” x 4” Bolt (76), two 3/8” Washers (38) and a 3/8” Nylon Locknut (42). Do not overtighten the Nylon

Locknut; the Pulley should turn easily. Make sure that the Cable is between the Pulley and the post, and that the Pulley Covers are turned so the wide tabs are on the indicated side.

35.Wrap the Rear Cable (87) around a 3 1/2” Pulley (82). Attach the Pulley and two Pulley Covers (62) to the Ab Upright (1) with a 3/8” x 4” Bolt (76), two 3/8” Washers (38) and a 3/8” Nylon Locknut (42). Do not overtighten the

Nylon Locknut; the Pulley should turn eas- ily. Make sure that the Cable is between the Pulley and the post.

33
		86
	32	40
	68	37
		44
		25	86
			32
			37
			44
34	Post
	76
	38	82
	62
Wide Tabs		87	38 42
	must be
	on this
	side
	1
35		1
	76		87
	38		82
			38
			42
			62

16