Weider WEBE15420 user manual Weight Rests should be set at the same height

3.Press two 2” Square Bushings (23) onto the Left and Right Uprights (4, 5). Slide the Weight Rests

(6)into the Uprights and secure them at the desired height with two Long Adjustment Knobs (27). Both

Weight Rests should be set at the same height.

4.Press two 38mm Square Inner Caps (32) into the ends of the Leg Lever (9). Press a 1” Round Inner Cap (21) into the indicated end of the weight tube. Slide a Weight Stop (34) over the weight tube.

Press a 1” Round Angle Cap (28) onto the opposite end of the weight tube.

Press four 3/4” Round Inner Caps (18) into the ends of two Pad Tubes (19). Slide the Pad Tubes into the holes at the ends of the Leg Lever (9). Slide four Foam Pads (33) onto the ends of the Pad Tubes.

5.Press two 3/4” Round Inner Caps (18) into the ends of a Pad Tube (19). Slide the Pad Tube into the large hole in the Front Leg (2) as shown. Slide a Foam Pad (33) onto each end of the Pad Tube.

Attach the Leg Lever (9) to the Front Leg (2) using an M10 x 64mm Bolt (12) and an M10 Nylon Locknut (11). Do not overtighten the Nylon

Locknut; the Leg Lever must be able to pivot freely.

3
	6			6
23	27
				23
5
					27
				4
4	33
			9
32			28
33			18	19
				18	33
	21
34
			18
	Weight	32
	Tube		19	18
				33
5
33		18
	19
		11
	9
			2	12
					33

7