Weider WESY19002 user manual En the Nylon Locknut the Pulley must be Able to turn freely

CABLE ASSEMBLY

27. Route the Long Cable (69) behind the Press	27
Frame (17) and under the Seat Frame (36) as
			36		75
shown. Route the Long Cable around two
3 1/2” Pulleys (15).
Slide the 3/8” x 5” Bolt (75) through the 3 1/2”					15
Pulleys (15), two Cable Traps (66), and the
Press Frame (17) as shown. Tighten a 3/8”				66
Nylon Locknut (21) onto the Bolt. Do not
overtighten the Nylon Locknut; the Pulleys	21			17
must be able to pivot freely.		15	69
28. Locate the section of the Long Cable (69)	28			36
between the two 3 1/2” Pulleys (15) attached			21
				9
in step 27. Route this section of the Long
Cable around a “V”-Pulley (6). Hold a Long
Cable Trap (50) against the Pulley to keep the			50
Cable in the groove of the Pulley.
			6
Attach the “V”-Pulley (6) and the Long Cable			69
Trap (50) to the second hole from the front of					15
			8
the Seat Frame (36) using a 3/8” x 3 1/4” Bolt
(8), a 3/8” Washer (9), and a 3/8” Nylon
Locknut (21). Do not overtighten the Nylon
Locknut; the Pulley must be able to turn
freely.
29. Route the Long Cable (69) around a 3 1/2”	29
Pulley (15). Hold a Cable Trap (66) against
the Pulley to hold the Long Cable in place.				15	64
Attach the 3 1/2” Pulley (15) and the Cable
Trap (66) to the Front Upright (42) using a
3/8” x 4 1/4” Bolt (64), a 3/8” Washer (9), and			66
a 3/8” Nylon Locknut (21).Do not overtight-
en the Nylon Locknut; the Pulley must be	21
able to turn freely.		9
					69
			42
30. Attach the end of the Long Cable (69) to the	30
Leg Lever (29) using a 5/16” x 2 3/4”
Shoulder Bolt (85), a 5/8” x 1/2” Spacer (82),
two 5/16” SAE Washers (88), and a 5/16”					29
Jamnut (87).
					69
				88	85
					88
					82
					87

15