Weider WEBE11880 manual Locknut, Bracket Lubricate Front View

7.Attach the Seat (9) to the indicated bracket on the Bench Frame (5) with two 1/4Ó x 1/2Ó Screws (3).

8.Press a 1 1/2Ó x 1 1/2Ó Inner Cap (7) into each end of the Leg Lever (14).

Slide the Weight Tube (17) into the Leg Lever (14) and secure it with a 5/16Ó x 2Ó Bolt (19) and a 5/16Ó Nylon Locknut (15). Do not overtighten the Nylon

Locknut.

Press a 1Ó Outer Cap (18) onto the indicated end of the Weight Tube. Press a 1Ó Inner Cap (16) into the indicated end of the Weight Tube. Slide a Weight Stop (55) onto the Weight Tube.

Lubricate the 3/8Ó x 2 1/4Ó Bolt (10). Attach the Leg Lever (14) to the bracket on the Bench Frame (5) with the Bolt and a 3/8Ó Jamnut (11). Do not overtighten the Nylon Locknut, it must be easy to pivot the Leg Lever.

9.Press a 3/4Ó Inner Cap (12) into each end of the two Pad Tubes (20).

Slide the Pad Tubes (20) into the indicated holes in the Leg Lever (14).

Slide a Foam Pad (13) onto each end of both Pad Tubes (20).

10.Locate the Cable (40). Note that one end of the Cable has a ball and the other a closed loop.

Attach the closed loop on the Cable (40) to the brack- et on the Weight Carriage (23) with a 3/8Ó x 1Ó Lat Bolt (26), a 3/8Ó Washer (31) and a 3/8Ó Jamnut (11).

Wrap the Cable (40) around a Pulley (42) in the direc- tion shown. Attach the Pulley and a Cable Trap (47) to the bracket on the Lat Upright (34) with a 3/8Ó x 1 1/2Ó Pulley Bolt (46) , and a Square Nut (30). Note:

The Square Nut fits into the bracket on the Lat Upright. It will be easier to hold the Nut with a pair of needle nose pliers while threading the Bolt into it. Make sure the Cable Trap is oriented as shown.

7		9
	Bracket
			5
			3
8	Lubricate		10
		14
			18	11
7		15
				5
55			19
		17
	16	7
9	13
12		14
			20
	13
				13
			13	12
10		46	47
	34			42
Front View		30		30
	Bracket	34		40
			11
	47
				26
46
				31
	42			23

8