ASSEMBLY
Make Things Easier for Yourself
This manual is designed to ensure that the slant board can be assembled successfully by anyone. Most people find that by setting aside plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the following information and instructions:
•Assembly requires two people.
•For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•As you assemble the slant board, make sure all parts are oriented as shown in the drawings.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
The following tools (not included) are required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
•Lubricant, such as grease or petroleum jelly, and soapy water.
Assembly will be more convenient if you have a socket set, a set of
1.Before assembling this product, make sure that you understand the information in the box above.
Press a 45mm Square Inner Cap (14) into the top of the Front Leg (2). Press two 50mm Round Outer Caps (12) onto the ends of a Stabilizer (4).
Attach the Stabilizer (4) to the Front Leg (2) with two M10 x 60mm Carriage Bolts (18) and two M10 Nylon Locknuts (19). Be sure the indents in the
Stabilizer and the decal on the Front Leg are in the positions shown. Do not tighten the Locknuts yet.
2.Press four 32mm Square Inner Caps (13) into the tubes on the Frame (1).
Attach the Frame (1) to the Front Leg (2) with two M10 x 60mm Bolts (17), two M10 Washers (20), and two M10 Nylon Locknuts (19). Do not tighten the Locknuts yet.
1 | 14 | |
| ||
Name | 2 | |
| ||
Decal |
| |
19 |
| |
12 |
| |
| 19 | |
4 |
| |
Indents | 12 | |
18 | ||
| ||
2 |
| |
13 |
| |
19 | 1 | |
| ||
20 |
| |
17 |
| |
20 | 19 | |
13 | ||
2 |
|
6