Assembly, Make Things Easier for Yourself

ASSEMBLY

Make Things Easier for Yourself

This manual is designed to ensure that the weight bench can be assembled successfully by anyone. Most people find that by setting aside plenty of time, assembly will go smoothly.

Before beginning assembly, carefully read the following information and instructions:

•Assembly requires two people.

•For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.

•Tighten all parts as you assemble them, unless instructed to do otherwise.

•As you assemble the weight bench, make sure all parts are oriented as shown in the drawings.

•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

The following tools (not included) are required for assembly:

• Two adjustable wrenches

• One rubber mallet

• One standard screwdriver

• One Phillips screwdriver

•Lubricant, such as grease or petroleum jelly, and soapy water.

Assembly will be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches.

1.Before beginning assembly, make sure you understand the information in the box above. Important: Some of the parts described in the assembly steps may be pre-assembled.

Press a 50mm Square Outer Cap (22) onto each end of the “U” Base (11).

Attach the Bench Leg (8) to the “U” Base (11) using two M10 x 58mm Carriage Bolts (34) and two M10 Nylon Locknuts (27).

2.Attach the Bench Frame (4) to the Bench Leg (8) using two M10 x 65mm Bolts (33), two M10 Washers (30), and two M10 Nylon Locknuts (27).

1
	8
	27
	11
	27
	34
	22
2	33
	33
30	4
27	33
27
	8
	30