Weider PRO XT75 user manual Part Identification Chart

Page 5

PART IDENTIFICATION CHART

Refer to the drawings below to identify small parts used in assembly. The number in parentheses by each draw- ing is the key number of the part, from the PART LIST in the center of this manual. Note: Some small parts may have been pre-attached. If a part is not in the parts bag, check to see if it has been pre-attached.

51mm Spacer (43)

M10 x 45mm Bolt (34)

M10 Flat Washer (41)

M10 x 50mm Bolt (47)

M8 Flat Washer (40)

28mm Spacer (44)

M10 x 66mm Bolt (37)

M8 x 72mm Bolt (35)

M10 Nylon Locknut (31)

24mm Spacer (42)

M10 x 75mm Bolt (36)

M8 Nylon Locknut (32)

18mm Spacer (45)

M10 x 78mm Bolt (33)

5

Image 5

Contents SEARS, Roebuck and CO., Hoffman ESTATES, IL Model No Serial No Table of Contents Important Precautions Before YOU Begin Using the Weider PRO XT75 weight rack. If youFor your benefit, read this manual carefully before Right SidePart Identification Chart Nylon Locknuts yet AssemblyMake Things Easier for Yourself Spotters and both Weight Rests are at the same height Tighten all Nylon Locknuts 31 used in steps Page Page Page Setting UP the Rack for Squat Exercises AdjustmentsUsing the Weight Rests and Weight Spotters Tightening the Cables Attaching Weights to the Weight CarriageExercise Guidelines Staying Motivated Muscle ChartCooling Down Qty Description Part LIST-Model NoExploded Full 90-DAY Warranty Ordering Replacement PartsModel No SEARS, Roebuck and CO., Dept WA, Hoffman ESTATES, IL